Process steps & methods: Fault analysis
Fault analysis is used to ascertain the fault characteristics and determine the subsequent procedure and selection of methods for fault location.
Insulation resistance measurement
to determine the faulty phase and the type of fault.
Cable sheath testing
to detect damage to the outer cable insulation (cable sheath faults).
Voltage test
to test the dielectric strength of the cable insulation.
BAUR products for cable fault location / fault analysis
shirla
Portable device
for cable sheath testing
and fault location
Syscompact 400
Cable fault location system for cable fault pre-location and pin-pointing
Syscompact 400 portable
Portable cable fault location system for cable fault pre-location and pin-pointing
Syscompact 4000
Cable fault location system
with IRG 4000
time domain reflectometer
titron®
Intelligent test van
for cable fault location
and diagnostics
transcable 4000/A 80-3
Cable test van:
3-phase, automatic,
80 kV
transcable 4000/S 110-1
Cable test van:
1-phase, semi-automatic,
110 kV
transcable 4000/S 32-3
Cable test van:
3-phase, semi-automatic,
32 kV
transcable 4000/S 70-3
Cable test van:
3-phase, semi-automatic,
70 kV